Description
Sales & System Planning — Seatech Marine Products
Newport 400C Automatic Marine Watermaker
NP-400C · standard configuration · select 12V or 24V DC
The Spectra Newport 400C (NP-400C) is an automated seawater reverse-osmosis watermaker for boats, rated to produce 17 US gallons (64 liters) of fresh water per hour. Its Spectra Connect controller lets you choose a timed run, a target volume, or Fill Tank operation with the tank-full switch installed. This standard system uses one 40-inch membrane; the compact model is a separate configuration.
Why choose the Newport 400C?
- Make fresh water aboard. Refill your tanks while cruising and reduce how often you need to find a dock-water supply.
- Match production to your routine. At the rated 17 GPH, a three-hour run produces about 51 US gallons before startup and flushing allowances. Actual output varies with feed-water conditions and operating voltage.
- Use your boat’s DC power. Choose the correct 12V or 24V version. A properly sized battery and charging system can support operation; solar or wind charging must be sized around your total onboard energy use.
- Choose output or efficiency. High and low operating modes give you flexibility when managing water demand and available power.
- Arrange the modules around available space. Plan separate locations for the feed-pump module, boost pump, membrane assembly, flush module, and display, with access for filter changes and service.
Plan the watermaker around your boat, power supply, and daily water use.
Included with the NP-400C system
- Seawater strainer and boost-pump module with service valve.
- Dual prefilter housings with 20-micron and 5-micron filter elements.
- Spectra magnetic-drive vane feed-water pump and two accumulators.
- Composite high-pressure Clark Pump, one 40-inch reverse-osmosis membrane, and pressure-vessel assembly.
- Spectra Connect remote touchscreen display with 100-foot cable, plus the tank-full switch.
- Automatic freshwater-flush module with charcoal filter, and a built-in three-way valve with quick-disconnect for service.
- 25 feet each of low-pressure product tubing, suction hose, and reinforced seawater hose, with supplied tube fittings and hose clamps.
- Handheld TDS tester, product sample valve, one SC-1 storage chemical, installation and operating manual, and warranty registration information.
Required for installation — plan or order separately
- A dedicated seawater intake through-hull, scoop strainer, and seacock, plus a suitable brine-discharge fitting.
- Boat-side power cable and circuit protection matched to the selected voltage and cable run.
- Connections to a properly vented freshwater tank and the boat’s pressurized freshwater supply for flushing.
- Suitable mounting locations, service clearance, and any extra hose, tubing, fittings, or mounting hardware required by your installation.
The supplied installation kit does not replace the boat-specific plumbing and electrical planning. Review the Newport 400C installation manual before selecting mounting locations or ordering installation parts.
Optional equipment and useful spares
- ZION-AUTO membrane-preservation system — the automated-system option for extending the freshwater-flush interval to as much as 30 days under the manual’s storage conditions. It is sold separately.
- KIT-SC-TNKSS tank-level sensor kit — optional tank-level information; distinct from the tank-full switch.
- Additional Spectra Connect display or Wi-Fi module — ask Seatech to match the display, cable, and network equipment to your controller and installation.
- Spare 20-micron prefilters, 5-micron prefilters, and the charcoal freshwater-flush filter.
- SC-1 storage compound for longer storage when appropriate. Freezing conditions require the separate winterizing procedure in the manual.
Connect controls, networking, and upkeep
Spectra Connect displays operating information and coordinates production and freshwater flushing. A phone, tablet, or computer can access the controller through the same onboard network when properly connected. This does not by itself provide access from anywhere over the internet.
Compatible Garmin, Raymarine, and Navico/Simrad multifunction displays can show the Spectra interface with the correct Ethernet connection and software. Spectra specifies Connect firmware v3.1 or later; Garmin connections also require the Marine Network PoE Isolation Coupler specified in the current manual. Confirm the exact MFD model and installation requirements before ordering network accessories.
Routine care includes checking for leaks and chafe, servicing the seawater strainer, replacing prefilters as their condition requires, and maintaining the freshwater-flush carbon filter. Automatic flushing needs DC power, pressurized freshwater, and enough water in the tank. Follow the storage or winterizing procedure when the boat will be left idle.
Technical specifications
| System | Spectra Newport 400C Connect — NP-400C, standard membrane configuration |
|---|---|
| Rated production | 17 US GPH (64 L/h); 400 US gallons (1,514 L) per day at rated conditions |
| Voltage and current | 12V DC @ 26A or 24V DC @ 13A, as listed in the current manufacturer fact sheet; select the correct voltage version |
| Membrane | 1 × 40-inch reverse-osmosis membrane |
| Prefilters | 20 micron and 5 micron; charcoal filter for freshwater flushing |
| Controls | Spectra Connect touchscreen; automatic production and freshwater flushing |
| System weight | 110 lb (50 kg) |
| Salt rejection | 99.2% |
| Temperature range | 36°F to 110°F |
| Rating conditions | 33,000 ppm feed-water salinity at 77°F (25°C) |
Daily capacity is the manufacturer’s rounded continuous-production rating. Plan your daily supply around the hours you expect to run, the water used for flushing, and local conditions. Confirm the electrical requirements for the quoted build before installation.
Downloads and resources
Updated May 2025 · 12V / 24V / 48V manual; use the instructions for your supplied version.
January 21, 2026 · standard system layout, module dimensions, and manufacturer specifications.
Revision C · January 3, 2024.
January 3, 2024 · for the 12V configuration.
January 3, 2024 · for the 24V configuration.
Network connection guidance; also see the compatibility notes in the current system manual.
Common buying questions
Is this the standard or compact Newport 400C?
NP-400C is the standard system with one 40-inch membrane. The NP-400CS compact system uses a different membrane arrangement and is ordered separately.
Can I run the Newport 400C from batteries?
The listed versions use 12V or 24V DC power. Battery capacity, charging capacity, cable size, and circuit protection must support the selected system. Solar panels or a wind generator may recharge the batteries; their presence alone does not establish that the power system is large enough.
Is a 48V factory version available?
Spectra also lists a 48V DC Newport 400C factory configuration. This catalog listing covers the 12V and 24V versions; request a quote for the 48V configuration so the voltage, equipment, and price can be confirmed before ordering.
How much water will a three-hour run make?
At the rated 17 GPH, three hours of production is approximately 51 US gallons before startup and freshwater-flush allowances. Actual production changes with seawater temperature, salinity, and operating conditions.
Can I control it from my phone or chartplotter?
A phone or tablet can access Spectra Connect on the same properly configured onboard network. Compatible chartplotters need the specified Ethernet connection, supported firmware, and any model-specific adapter. Internet access from shore is a separate networking question.
Do I need Z±ION?
Z±ION is optional. The Newport 400C already has freshwater flushing. ZION-AUTO can extend the flush interval under the manufacturer’s conditions; it does not replace winterizing or every long-term storage procedure.
How does Connect differ from Remote Manual?
This NP-400C uses the Spectra Connect touchscreen and automated run modes. The NP-400R Remote Manual is a separate model with a different control package. Choose the controls and installation layout that fit your boat.
Plan your system with Seatech
Spectra Watermakers manufactures the system. Seatech Marine Products is an authorized dealer. Send your daily water-use estimate, preferred running hours, boat voltage, and photos or measurements of the proposed mounting areas. We can help identify the system and installation parts to include in your quote.
Plan the watermaker around your boat, power supply, and daily water use.
Ordering, warranty, and earlier-system references
- Standard manufacturer warranty: One year, subject to Spectra’s limited-warranty terms.
- Extended-coverage program: Spectra describes two-year system coverage and lifetime Clark Pump coverage through its authorized full-service-provider program. Installation and commissioning by an authorized FSP, owner registration, submission of the commissioning report, and factory approval are required. See the manual for coverage, eligibility, and exclusions.
- No sales tax on purchases outside of California
- Built to Order - Average 30 day lead time
Manufacturer terms, registration, and commissioning requirements apply. Confirm current availability and lead time before ordering.
Earlier system reference from this listing: NP-MK IIZ-400. A refit requires checking the existing plumbing, wiring, and controls rather than assuming an unchanged installation.
International Customers: We Ship Worldwide, Shipping Cost May Quote Too High on Our Web Site, contact us for a quote.
Because Spectra has MAP pricing on all its systems, we can only offer a low price directly. Use the Spectra quote form above for pricing.